.png)
您當(dāng)前的位置: Troubleshoot
搜索
2023-11-14First, move the upper ingot assembly to the position shown in Figure 1. The upper ingot plate parking is facing the center of the mountain shaped part, which is also the position where the upper ingot parking rod is extended the longest, as shown in Figure 2
If the wire is broken, do not stop the machine. First, check if the brake block in circle 1 can be hit when the wire is broken. You can apply easily fading pigments (such as chalk, red lead, etc.) to the brake block and the position where the upper and lower ingot parking rods are hit, and observe whether there is fading to determine.jpg "1699516567117370(2).jpg")
Close the front door, open the side door (or open the front door, close and press the front door with the door switch), then press the reset button, and then press the start button (this is an unconventional operation, please pay attention to safety!), observe whether the brake block circled in Figure 1 has been hit
2023-11-03The quality of wire blending has a crucial impact on the frequency of wire breakage in weaving machines
The reason for the breakage of the weaving machine cannot be found and can be determined using the elimination method. Firstly, we need to rule out two points: whether the height of the weaving mold eye is at the appropriate height (please refer to relevant articles for adjustment), and secondly, whether the threading is too fast or too slow
2023-11-02The machine keeps showing that the door is open. First, check the following three positions
Before adjusting the speed of the threading position, it is necessary to first adjust the height of the weaving die eye (please refer to relevant articles for how to adjust)
The height of the weaving die eye is determined by the large V-shaped guide rail. To adjust the height of the mold eye, it is necessary to operate with woven wire hanging on the lower ingot. Firstly, move the adjacent wires to an equal height position
2023-10-30First roughly fix the position of the cable guide assembly
In order to make the tension of the cable reel more uniform, the braking force of the cable reel needs to be adjusted before use